Infranoto
All toolbox talks
General

Fall Protection Awareness

5 minutes

Falls from height don't leave much room for a second chance. They also tend to happen on the quick jobs, like checking something on a roof, working near an open edge for a minute, or stepping past a guardrail to reach a valve.

OSHA generally requires protection from falls at 4 feet in general industry and 6 feet in construction, and some tasks have different rules. Before work starts, make sure you know what applies to this job.

Key points

  • Identify fall hazards before you start, including unprotected edges, floor holes, skylights, and open pits.
  • Use guardrails or covers first when they're available. They protect people without anyone having to clip in.
  • Inspect your harness and lanyard before every use. Look for cuts, fraying, burns, damaged hardware, and an activated fall indicator.
  • Tie off only to an approved anchor, never to a pipe, conduit, or guardrail that wasn't designed for it.
  • Check your fall clearance. A lanyard and its deceleration distance need enough room below you to stop before you hit something.
  • Have a prompt rescue plan before anyone goes up. Remove any equipment that has stopped a fall from service right away, and don't reuse it unless a competent person inspects it and clears it.

Discussion questions

  • Where on this job could someone be exposed to a fall for just a minute or two?
  • Does everyone know which anchor points are approved for today's work?
  • If someone fell and was hanging in a harness, exactly how would we get them down?